KT-400 Ethernet-ready four-door controller supports eight readers (EntraPass Security. Management Software) and can be configured in two user friendly How do I add a new controller to kantech? a) Click the Status tab on the EntraPass toolbar followed by the Text button. b) In the text status window, click the controller icon, select the controller then click OK . Make sure communication was established. c) If not, • Go to Devices Site to make sure that the correct COM port is selected. fileslib. How many kantech controllers can you put on a communication loop? Up to 32 controllers in daisy chain configuration. Select EntraPass Web from the list box and then click the Click here to install component button. The lastet version of Entrepass is version 8.30, which
What is the default IP address of a KT 400? Forced default static This is the same as the soft reset mode, except that the IP address resets to the default static IP: 192.168. 1.2 .
The KT-1 One Door Controller shall be installed and used within an (KT-100, KT-300, KT-400) and communicates with the EntraPass Gateway, only.