POST MOUNT INSTALLATION INSTRUCTIONS Deck Mount Kit (sold separately) includes (1) 8 hole bottom base plate, (1) 4 hole surface plate, (4) 6" mounting bolts and (4) 5/16" leveling screws. Note: Max allowable rail span is governed by rail manufacturer. THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT The mount comes with installation instructions and necessary hardware for installation. Buy with confidence. Features / Specifications: - Low-profile design - Tilt downwards 15 degrees - VESA 75 and VESA 100 bolting pattern compatible - Easily installs to one wall stud or concrete, brick wall - 30 lb load capacity - Material: Steel For flashing details see Shake, Slate and Metal Mount Installation Instructions for flashing guidelines. Composition Shingle Roofs For flashing details see QBase Composition Mount Installation Instructions step 6-8. 3.75" 5" 7" 9" Composition Shingle Asphaltic Roofing Single Ply Membranes Tile Shake Slate Metal Shingle 12" 13" 15" 18" Mount Angle Wizard 2×3-1:2 Stair Bracket Installation Instructions. Angle Wizard Post Mount Installation Instructions. Angle Wizard T-Rail Porch Bracket Installation Instructions. Angle Wizard T-Rail Stair Bracket Installation Instructions. Blu Mount Post Mount Installation Instructions for Concrete Application. Blu Mount Post Mount Installation The Leupold M3A/M3 were made with 20MOA cant built-in. The purpose was to zero at 100y with a zero-cant base, and get to 1000y with only one full revolution of the turret. The M3A elevation turret is 1MOA per click. People buy M3A/M3, mount in on a canted base (ex 20MOA), and then wonder why it wont zero at 100y. Install Planted Side Mounts onto Seat(s) - Using the 4 bolts & washers from the Planted Side Mount Hardware Kit loosely attach the Planted Side Mounts to the side of the seat(s). The slotted end of the side mount is the front and the end with the holes is the rear because this is where the majority of your weight will be when sitting in the seat. Installation Instructions for our range of structured cabling, data center connectivity and smart building solution products. x. CUSTOMIZE YOUR EXPERIENCE. 0183380002 - DataGate Plus, Surface Mount Installation Instructions (164 KB) 0183500001 - VarioKeystone Insert Connection, Removal, Exchange InstructionsInstallation Instruction (318 KB) Installation Instructions STEP 1 Determine placement of mount on wall. Place the mount on the wall and attach STEP 2 Install the siding according to the manufacturer's installation instructions, ensuring the mount is properly flashed. Caulk the sides and bottom of mount where siding meets the mount. STEP 3 Attach the fixture to the Mount. Concrete Mount Installation Instructions Step 1: Layout the locations for the post mounts. Step 2: Using the post mount as a template, mark the drill locations for each of the four corner holes. Step 3: Using a ¼" masonry drill bit, drill the four holes to a minimum depth of 3 ½". IMPORTANT: Thoroughly clean the holes from all dust and debris. Step 4: Place the post mount into position Swivel Ball Floor Mount Installation Instructions For Part Number's 2400500040, 2401500040, 2402500040, 2400550040, 2401550040, 2402550040 ididit 610 S. Maumee St. 49286 Tecumseh, MI • PH: 517-424-0577 • FAX: 517-424-7293 Install column into drop or dash mount. 8. Slide floor mount down until it sits flat against floor and the 3 bolts I